I'm trying to setup 3 servers on a VSP and I have one server running fine, problem I fire up the other two they show up fine under the in game browser with the right gametype and name but when you join either of them you get put into the original server.

 

I have noticed no matter what I use as the queryport when I fire up the server in the console it shows gameport 2715

 

Each servers command line are below, I have tried switching them up to no avel

+set net_queryport 27015 +set net_port 27016 +set net_masterServerPort 27017 +set sv_config "server.cfg" +start_map_rotate

+set net_queryport 27018 +set net_port 27019 +set net_masterServerPort 27020 +set sv_config "server.cfg" +start_map_rotate

+set net_queryport 27020 +set net_port 27021 +set net_masterServerPort 27022 +set sv_config "server.cfg" +start_map_rotate

 

Any ideas ?

Maybe the port is being set inside server.cfg? (remove the commands from the cfg if it's happening)

Plus, there are 2 problems in those shortcuts. I once ran some tests and couldn't use port 27016 (it was skipping to 27017). Avoit that port.

Plus, on your last 2 servers, you used port 27020 on both shortcuts.

Commands are commented out in the config ,

 

And I have tried 20 different configurations and no matter what you are directed to the 1st server I fire up.

I fire up ffa 1st and then fire up tdm you will load the ffa server even though you joined the tdm from the browser list..

 

I have noticed that no matter what I set it to upon start up in the console it list " Initializing Steam Game Server: game port 27015 " even if I choose 27020

 

Any help for a noob that is lost...

Figured out why the query port isn't changing from 27015

Anything other than 27015 as the query port will default back

 

I get this on startup in the console, anytime I use anything other than 27015

net_queryPort is write protected.

 

The two servers I'm running are in separate folders running separate configs, on the below command lines.

The second servers query port always defaults back to 27015

 

+set net_queryport 27015 +set net_port 27016 +set net_masterServerPort 27017 +set sv_config "server.cfg" +start_map_rotate

 

+set net_queryport 27018 +set net_port 27019 +set net_masterServerPort 27020 +set sv_config "server.cfg" +start_map_rotate

 

Is there anyway to fix this? :cry:

Try using upper case P...

+set net_queryPort

2nd server = +set net_masterServerPort 27020 (note: port 27020)

 

3rd server = +set net_queryport 27020 (also port 27020)